ComosystemsUSA.com is now online.

FREQUENTLY ASKED QUESTIONS

The following questions are frequently asked, however if you have any other questions regarding EM pollution and CMO technology that are not answered below please contact us and we will endeavour to answer your queries.


1. Why does the Industry and Authorities claim that mobile phones, WiFi and Smart meters are safe?

Safety levels are based on an outdated belief that in order to cause biological affects, EMFs must have a thermal effect (i.e. have a heating effect). This belief was the basis of the SAR scale which is still used to determine safety levels. Industry-sponsored research is used to justify the ongoing expansion of the use of EMFs, whereas independent research provides much evidence of the dangers. It has been proven beyond doubt that EMFs do not need to cause a thermal effect to alter our biology however much the Industry denies it.

2. Why are pregnant women, babies and children most at risk?

The ability of EM radiation to penetrate the body is determined by its wavelength. The smaller the body, the further the same wavelength penetrates into it proportionally. This is most easily demonstrated by showing the heating effect of a mobile phone on the skulls of people of different ages. Children also have thinner skulls.

Developing foetuses, babies and children also have much higher numbersof stem cells which research has demonstrated are more susceptible to EMFs than already differentiated cells.

3. Why is 5G more dangerous than 2, 3 or 4G?

With the massive increase in the amount of communications, the bandwidth used for 2-4G has all but been used up. New forms of communication must therefore use a different frequency. 5G is a higher frequency which has advantages for data carriage and download speeds in terms of Gb/sec compared to the current Mb/sec. However the downsides are that the higher frequency has greater heating effects, is more disruptive and because it cannot be relayed over such long distances requires a network of 5G masts much closer together which means that there will be many more masts (sources of EM radiation) in closer proximity to people, their homes and offices. In cities, 5G masts will be placed approximately every 5-10 houses on street lights. The strength of the signal is highest closer to the masts which means many more people will be forced to live in close proximity to them with little prospect of being able to move away from them. These higher frequencies also cause much greater harm in insects such as bees who we rely on for pollination for food production.

4. How does CMO help?

A CMO device is stimulated by the EM radiation that hits it to generate a compensating signal which reinforces the correct biological frequencies within the cells of those within range. This reinforcement signal prevents the EM pollution from interfering and disrupting our normal biological processes. This means our cells function as normal, allowing us to live in harmony with EM-generating technology safely. The CMO compensating signal does not alter the functionality of the technology so we can still benefit from using it.

5. What proof is there that CMO works?

There has been 10+ years of research performed by independent scientists that have proven that CMO devices mitigate the adverse effects. These have been carried out on a number of stress markers in people as well as an ant study because they are very susceptible to the adverse effects of EMFs but representative of how insects generally are effected. There have been no negative research papers. There have also been many testimonials from people around the world who have benefitted from CMO. Original CMO technology devices were first built 25 years ago and are still fully functional today according to in-house research.

6. Has CMO got official recognition?

The AFSSAPS (French Health Products Safety Agency) tested CMO to establish if the public were being led astray.
After rigorous testing they authorised Comosystems in a public declaration to allow us to make the following statement
"CMO is probably the best way today to compensate for the biological effects induced by artificial EMFs".

7. If I buy a Harmony do I still need to buy a PCZone for my laptop/tablet or an EasyCall for my mobile phone?

Ideally, yes.  A Harmony will deliver full protection against mobile phones and laptops when they are away from the body on charge or on a table etc, however we tend to use them right next to the body. An Easycall and PCZone will provide additional benefit when a mobile/laptop/tablet is used close to the body and in the case of a mobile, often carried in a pocket right next to the body too. The extra protection is required because the power output from when devices are used so close is much higher than the general level of EMFs we experience from more distant multiple sources. The Harmony and Traveller can deal perfectly well with these. The stochastic resonance mechanism in the body naturally amplifies the CMO to mitigate against these levels of EMF.

When a mobile/laptop/tablet are so close they can swamp the CMO signal unless it is introduced more directly from a closer source of CMO device too. Of course many people have a mobile and laptop/tablet because they are fully portable and they often take them out and about outside the home and outside the range of the Harmony too. An Easycall and PCZone are needed for this situation.

The significantly higher power of personal devices is perfectly demonstrated by the French mobile phone research results graph below that shows how much higher than the permitted levels the EMF absorption (SAR) becomes when mobile phones are used in direct contact with the head. This exceeds permitted levels in many cases multiple times. Similar results were found for later model phones too in research published in the USA in 2019.  Mobile phone small print often tells users to use the mobile 15mm away from the body and not in direct contact, but how often do we ignore this in order to hear clearly in a loud room, and how can you comply with this instruction if you carry it in your pocket?

8. If I change my phone or PC/tablet/laptop can I move my CMO to my new device?

Yes!
NB: In order to remove your CMO button, we advise you to take a simple nylon thread, slide it between the CMO and the phone (or PC/laptop/tablet), and shear the adhesive pads off in order to loosen the CMO delicately.You can get new adhesive pads from an office supplies or hobby store. To ensure better adhesion, the surface of the device and Easycall/PCZone must be clean and smooth so the adhesive can stick properly.

CAUTION: Never attempt to remove a CMO button from a device on which it is glued by pulling or using a knife to peel it off. You risk weakening the seal between the two metal parts enclosing the active solution. The guarantee does not apply if the CMO becomes unsealed after an unsuitable removal or otherwise abused.

We also advise you to remove traces of the old adhesive from your CMO (and the old phone) with 70° alcohol. Once the area is clean and dry, you can put the new adhesive pads on your CMO and finally stick it onto your new device.

9. How long will it take to notice any difference?

This is an individual response determined by a number of factors. Different people experience EMFs to different degrees. The latest figures from countries who are very much more aware of electrosensitivity than the UK suggest that around least 8% of the population suffer from EM pollution and are termed Electro HyperSensitive (EHS). Whilst many people are individually unaware of adverse effects everybody is adversely effected with many experiencing lesser symptoms to some degree that they do not consciously associate the the EMFs that have caused them. How long it takes for an individual to feel better will therefore depend on how badly they are affected, how quickly their cells and body can reverse the changes, how strong their exposure is and whether they are covered by CMO at work as well as at home etc. Many CMO users report the disappearance of symptoms they had not previously associated with EMF exposure.

10. How does the network signal strength as shown on a mobile phone correlate to the strength of the emitted EMFs?

Contrary to what you may think, the weaker the network signal, the harder your mobile phone has to work to maintain the connection. This means the emitted EMFs are potentially more harmful when you are making calls in a weak signal area, or in enclosed spaces such as a car etc.  This is why other so-called protection devices that claim to cut out or absorb EMFs can actually make the situation worse.  Even ultra-low EMFs can penetrate a Faraday cage and cause biological effects. A tin foil hat will not protect you!!

11. How is CMO affected by temperature?

CMO technology is stable from freezing to 65°C. Due to the crystalline solution it freezes below 0°C. When CMO freezes there is temporary interruption of the mitigating signal which regains its efficacy when it thaws. Above 65°C the mitigating signal is irretrievably destroyed. Under normal UK and Eire weather conditions CMO should not be at risk, however we advise not keeping your CMO in an area where sunlight may be magnified and amplified through glass.

12. How is CMO affected by security X-ray etc?

CMO technology is designed to function within EMF pollution zones.  There are no issues arising from your Traveller and/or Easycall and/or PCZone going through security scanners or X-ray detectors. Just put them in the tray as usual and there should be no problems.

13. How does CMO technology compare with other devices that claim to protect from EMFs

Firstly, CMO does not claim to be a shield against EMFs. It is not possible to shield the body from all EMFs even if you are in some sort of Faraday cage. Ultralow EMFs can still get through and cause a biological effect. Only mu metal can cut out all EMFs.  If you were truly shielded then the technology will not work within the influence of the shield. CMO works by emitting a compensation signal that influences the body.  This has been verified through a number of research studies and by multiple scientists in different universities and laboratories that prove a real beneficial biological effect. It is up to other technologies to verify their own efficacy and establish how they work in repeated experiments at high level research establishments. The true measure of how well any material or device can protect you is the actual biological effect and changes in biomarkers, not whether it can absorb EMFs that hit it.
Some people attempt to build themselves a Farady cage-like arrangement for protection which can cut out man-made EMFs but can also cut out natural ones that the body requires to be healthy. A Faraday cage can exacerbate symptoms in some situations.
To our knowledge no other technology has been tested to the same extent as CMO.

14. Where are CMO manufactured?

CMO technology is still manufactured in France although the Head Office for the business is located in Spain.